Alliance Laundry Systems HCN020HCF Instruction Manual download pdf (Page 33)

Programming Control

31

F8237701

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

10. Error Code Programming “Err-”

This option allows the owner to turn on or turn off

certain errors in the control.

How to Program Error Code Programming

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the Cold ( ) or the Delicate Cold ( )

keypad until “Prog” appears in the display. Press

the START (enter) keypad and “AtS” will appear

in the display.

3. Press the Cold ( ) or the Delicate Cold ( )

keypad to scroll through the programmable

options until “Err-” appears in the display.

4. When “Err-” appears in the display, press the

START (enter) keypad. Refer to Table 6 for a list

of programmable error code parameters.

>

<

>

<

“CEr-” Coin Error Parameters

“CEr1” Coin Error - Determines if

display will show error.

“CEr2” Coin Error Penalty - If enabled,

coin error will erase previous

coins entered and reset the vend

price.

“CEr3” Coin Drops Header

Present Error - If enabled and

coin drop header is unplugged,

control ignores coin inputs.

“EFL” Fill Error

“Edr” Drain Error

“EUb” Unbalance Error Display (VFD only)

“EoP” Open Thermistor Error Display

(Models with Heat)

“ESH” Shorted Thermistor Error Display

(Models with Heat)

“EHt” Heat Error Display (Heater only)

“LEr-”

Leak Detection Error

If Water Leak Detection during a machine

cycle is enabled, the control will check for

water leaks during running machine cycles.

If a leak is detected, the control will display

the “E Ld” error for one minute after the

cycle is completed. It will also light the

right-most decimal point on the display. The

Water Leak Dectection diagnostic test can be

used to verify the leak.

“LEr1”

Water Leak Detection

During a Machine Cycle –

Determines if water level drops

below target level.

“LEr3”

Number of cycles between leak

detection tests.

“E Sd”

Slow Drain Detection – Determines if

machine is draining slower than

normal.

If Slow Drain Detection is enabled, the

control will check for slow drain operation

during running machine cycles. If a slow

drain is detected, the control will display the

“E Sd” error for one minute after the cycle is

completed. It will also light the right-most

decimal point on the display.

Table 6

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 69 70

Comments to this Manuals

No comments