Alliance Laundry Systems HCN020HCF Instruction Manual download pdf (Page 31)

Programming Control

F8237701

9. Audio Signal “AUd”

This option allows the owner to program when the

signal will sound.

There are five occasions when a signal may sound

during operation. These five occasions are listed

below:

1. End of Cycle Signal

By default, the signal is turned off. If turned on,

the signal will sound for three (3) seconds at the

end of a cycle.

2. Keypad Depression Signal

By default, this signal is turned on and will sound

for a quarter of a second. This signal will sound

each time a keypad is pressed.

3. Coin Input/Card Insertion Signal

By default, this signal is turned on and will sound

for a quarter of a second each time a coin or card

is entered.

4. Remove Card Signal (Card Models Only)

By default, this signal is turned on and will sound

one (1) second on and one (1) second off when

the control is prompting for card removal.

5. Signal for Start

By default, this signal is turned on and will sound

one (1) second on and one (1) second off for 10

seconds after vend price has been satisfied.

How to Program the Audio Signal

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the Cold ( ) or the Delicate Cold ( )

keypad until “Prog” appears in the display. Press

the START (enter) keypad and “AtS” will appear

in the display.

3. Press the Cold ( ) or the Delicate Cold ( )

keypad to scroll through the programmable

options until “AUd” appears in the display.

4. When “AUd” appears in the display press the

START (enter) keypad. A number will appear in

the display. This number corresponds to the

current Audio Signal Programming Value.

5. Locate the desired number in the first column of

Table 5 on the following page.

6. Press the Cold ( ) or the Delicate Cold ( )

keypad to increase or decrease the current

number until correct.

For Example: A user might wish to have the signal

sound only when a keypad is pressed. Entering the

number “1” in step 5 would turn off all the options

except KEYPAD. In this instance, the signal would

sound only when a keypad is pressed.

7. Press the START (enter) keypad when the correct

number appears in the display. The next option,

“Err-”, will appear in the display.

NOTE: To program “Err-” (Error Code

Programming), refer to option 10. To program

other options, refer to the appropriate section.

How to Exit Programming Feature

Press the Delicate Warm (<) keypad until the control

returns to Ready Mode.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 69 70

Comments to this Manuals

No comments

Alliance Laundry Systems HCN020HCF Instruction Manual Page 31

Comments to this Manuals

Related products and manuals for Washing machines Alliance Laundry Systems HCN020HCF