Alliance Laundry Systems HCN020HCF Instruction Manual download pdf (Page 21)

Programming Control

F8237701

Figure 6

CHM1392R

(continued)

“SUPC” (Design 1 only) - Choose either

supply dispenser or compartment dispenser.

“IrA” - Enable/disable the ability to read

the control by an external device.

“t FC” (Models with Heat) - Set

temperature shown in Fahrenheit or Celsius.

“FH” (Models with Heat) - Set

the temperature of the hot water.

“FHC” (Models with Heat) - Set the

temperature of the warm water.

“FC” (Models with Heat) - Set the

temperature of the cold water.

“Codn” (Models with Heat) - Enable/disable

the cool down water temperature option.

“PtEn” - Enable/disable access to the

production test cycle.

“rAEn” - Enable/disable the rapid advance

feature.

“nCtd” - Enable/disable whether the cycle

time will appear in display.

“bALr” (VFD only) - Program the number

of times control will retry balancing the

load before moving to extract step.

Dispenser:

“S” = Supply Dispenser

“C” = Compartment Dispenser

Temperature:

“CEL” = Celsius

“FAHr” = Fahrenheit

“SdAd” - Enable/disable slow drain

detection. When enabled can

increase/decrease the time before a

slow drain error will occur.

“SPAU” - Enable/disable

Pause/Resume mode.

“PCtd” - Enable/disable programmable

cycle time display.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 69 70

No comments

Alliance Laundry Systems HCN020HCF Instruction Manual Page 21