Alliance Laundry Systems HCN020HCF Instruction Manual download pdf (Page 13)

F8237701

Opening the Top Cover

To manually program the control, the top cover must

be opened. Opening and closing the top cover trips a

switch which allows access to various programming

options. Once opened, the top cover may either be left

open, and then closed after programming, or it may be

closed immediately.

The top cover is located on the top of the machine.

1. Unlock top cover.

2. Slide top cover forward slightly to move notches

away from the pegs on the front of cabinet.

3. Lift the top cover up. To completely remove, lift

top cover away from both top cover hinges. Refer

to Figure 2.

After opening, or opening and closing the top cover,

the operator has 4 minutes and 15 seconds to begin

programming. If the appropriate Select Cycle Pads

have not been pressed in that time, the control will not

accept operator programming. Should this happen,

opening and closing the top cover will once again trip

the switch which allows access to the programming

options.

Figure 2

CHM1357R

1 Top Cover Lock 3 Top Cover Hinge

2 Top Cover 4 Peg

CHM1357R

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 69 70

No comments

Alliance Laundry Systems HCN020HCF Instruction Manual Page 13