© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
F8237701
14
Table 1 (Continued)
Option
Number
Option
Display
Description
Default
Value
Value
Range
i. “ESd” Slow Drain Detection oFF on/oFF
11 “CyC-” Cycle Programming Refer to Cycle Chart for default cycle information
a. “AgIt” Cycle Agitate --
1. “tyPE”Agitate Type ** 1 - 2*
2. “ASPd” Agitate Speed (VFD only) ** Lo/rEg*
b. “Seg-” Cycle Segment Programming
1. “SgEn” Segment Enable/Disable ** on/oFF
c. “FILL” Fill Step --
1. “FLEn” Fill Step Enable/Disable ** on/oFF
2. “FLEU” Fill Level ** HI/nEd/Lo
3. “tEnP” Fill Temperature ** CoLd/UArn/Hot
d. “SUPL” Supply Step --
1. “SUEn” Supply Step Enable/Disable ** on/oFF
2. “dISP” Dispenser Options ** For Design 1 models, display will show
Cx (compartment-oriented) or Sx
(supply-oriented), depending on how
option 5 (Supply/Compartment
Dispenser Programming) is
programmed.
For Design 2 models, Compartment and
Supply dispensing is programmed
separately.
Press START keypad to access
options.
a. “C2” or
“S1”
Compartment #2/Supply #1
(Design 1 models)
** on/oFF
b. “C3” or
“S2”
Compartment #3/Supply #2
(Design 1 models)
** on/oFF
c. “C4” or
“S3”
Compartment #4/Supply #3
(Design 1 models)
** on/oFF
d. “S4” Supply #4 (Design 1 models) ** on/oFF
(1) “C2” Compartment #2 (Design 2 models) ** on/oFF
(2) “C3” Compartment #3 (Design 2 models) ** on/oFF
(3) “C4” Compartment #4 (Design 2 models) ** on/oFF
(4) “S1” Supply #1 (Design 2 models) ** on/oFF
(5) “S2” Supply #2 (Design 2 models) ** on/oFF
(6) “S3” Supply #3 (Design 2 models) ** on/oFF
(7) “S4” Supply #4 (Design 2 models) ** on/oFF
*Refer to programming section for value definition.
**Refer to the Cycle Charts for default cycle setting information.
Table 1 (Continued)
Comments to this Manuals