Alliance Laundry Systems HCN020HCF Instruction Manual download pdf (Page 15)

F8237701

Programming Control

What Can Be Programmed?

This feature allows the owner to program cycle

information, standard vend pricing, special vends and

other features by using the keypads. The control must

have the Manual Programming Mode enabled, which

is the factory default. This mode can only be turned

“OFF” and “ON” by using an external device. Refer to

this section when programming the control.

This section offers a detailed description of all available

programmable options.

Each description includes instructions on when and

why the option might be used and, more importantly,

how to program the option.

For more advanced users, a quick reference list (refer

to Table 1) and programming flowcharts (refer to

Figure 3 through Figure 7) of the options available

through the programming mode are located on the

following pages.

NOTE: The letters and numbers in the Option

Display column of the Programmable Options List

are what will be shown in the display when that

option is selected.

Programmable Options Available

Option

Number

Option

Display

Description

Default

Value

Range

1“AtS” Cycle Vend Price 200 0 - 65535

2“dEn1” Coin #1 Value 25 1 - 65535

3“dEn2” Coin #2 Value 100 1 - 65535

4“PLSE” Start Pulse Value 25 1 - 65535

5“PLSn” Start Pulse Mode 128 oFF/128/192

6“AtyP” Available Type 00 - 3

7“dCYC” Default Cycle 5* 1 - 8*

8“oPL” OPL Mode Enable/Disable oFF on/oFF

9“AUd” Audio Signal 29* 0 - 31*

10 “Err-”Errors --

a. “CEr-” Coin Error Parameters --

1. “CEr1” Coin Error on on/oFF

2. “CEr2” Coin Error Penalty oFF on/oFF

3. “CEr3” Coin Drops Header Present Error on on/oFF

b. “EFL” Fill Errors on on/oFF

c. “Edr”Drain Error on on/oFF

d. “EUb” Unbalance Error Display on on/oFF

e. “EoP” Open Thermister Error Display on on/oFF

f. “ESH” Shorted Thermistor Error Display on on/oFF

g. “EHt” Heat Error Display (Heater only) on on/oFF

h. “LEr-” Water Leak Detection Error --

1. “LEr1” Water Leak Detection During a Machine Cycle

(On/Off)

oFF on/oFF

2. “LEr3” Number of cycles between Leak Detection Test

0* 0-127*

*Refer to programming section for value definition.

**Refer to the Cycle Charts for default cycle setting information.

Table 1 (Continued)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 69 70

Comments to this Manuals

No comments

Alliance Laundry Systems HCN020HCF Instruction Manual Page 15

Comments to this Manuals

Related products and manuals for Washing machines Alliance Laundry Systems HCN020HCF