Alliance Laundry Systems HCN020HCF Instruction Manual download pdf (Page 57)

Error Codes

F8237701

Table 17 (continued)

Display Description

Cause/

Corrective Action

E do

Door Open Error Control detects door open. Caused by pulling on door

while locked or about to lock. Correct inoperative door

locking system. End cycle. Power down machine to

clear.

E Ub

Unbalance Error Unable to balance load. Redistribute load and run cycle.

door

Door Open Indicator Door is not closed in Start Mode. If door is closed, check

for improper wiring or faulty door switch.

Err

Coin Error Invalid coin pulse or inoperative coin sensor. Check coin

drop area and remove obstructions. If error persists,

tampering may have occured. Evaluate security

procedures.

E dr

Drain Alarm Error Machine not drained within 15 minutes (or other

programmed length of time) in any drain step. End

cycle. Power down machine to clear.

E Ht

Heat Alarm Error Programmed heat alarm time of 120 minutes or other

programmed length of time is exceeded. Turn off heater

output for remainder of cycle.

E oP

Open Temperature Sensor Error Control senses temperature less than 0°F (-18°C) in

machine equipped with temperature sensor. Heater and

thermistor related operations are disabled.

E SH

Shorted Temperature Sensor Error Control senses temperature greater than 220°F (104°C)

in machine equipped with temperature sensor. Heater

and thermistor related operations are disabled for

remainder of cycle.

E ro

Rotation Sensor Error Invalid signal received from Rotation Sensor. Control

will activate coast times to complete cycle.

E FS

Frame Balance Switch Error Control detects Frame Balance Switch open. End cycle.

E db

Drive Balance Switch Error Control detects VFD Balance Switch input closed at

start of drain step. End cycle. Power down machine to

clear.

E Ld

Water Leak Detection Error If control senses a drop in water level during diagnostic

testing. Power down machine to clear. Control shows

error after door is open (when cycle is completed) for

one minute, lights the right-most decimal point* on

display and the error information will be logged in audit

data.

E Sd

Slow Drain Error Control shows error after door is open (when cycle is

completed) for one minute, lights the right-most decimal

point* on display and the error information will be

logged in audit data.

*To clear the decimal point on display, press the START (enter) button 3 times in succession (within 5 seconds).

**Design 2 models only.

Table 17 (continued)

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 69 70

Comments to this Manuals

No comments

Alliance Laundry Systems HCN020HCF Instruction Manual Page 57

Comments to this Manuals

Related products and manuals for Washing machines Alliance Laundry Systems HCN020HCF