Alliance Laundry Systems HCN020HCF Instruction Manual download pdf (Page 10)

F8237701

Machine Operation

Start Up

When power is applied to the machine, the control will

display its software version as “S xx” (“xx” is the

version number) for one (1) second. If the control was

not powered down during a running cycle, it will enter

Ready Mode, Partial Vend Mode or Start Mode.

Ready Mode

In this mode of operation the control indicates the

current selected cycle by lighting the LEDs. The full

current vend price for the cycle appears in the display.

To start the cycle, the user must satisfy the vend price

and then press the START keypad.

The user will be able to select a different cycle by

pressing a cycle pad when the machine is in Ready

Mode.

Partial Vend Mode

The control enters this mode when part of the vend

price has been entered, but not enough vend is entered

to satisfy the vend price. The control will display the

remaining vend price needed to start the cycle.

The user will be able to select a different cycle by

pressing a cycle pad when the machine is in Partial

Vend Mode.

Start Mode

The control enters this mode when the full vend price

is satisfied, the vend price is zero, the control is in

OPL Mode or the correct Drop Off Mode key

sequence is entered. The START pad LED will flash

one (1) second on and one (1) second off. If Start

Mode is entered because the vend price is satisfied or

the control is in OPL Mode, the display will show

“PUSH” for one (1) second, “Strt” for one (1) second

and the current cycle time for one (1) second. If Start

Mode is entered because the vend price is zero, the

display will show “FREE”. When first entering Start

Mode, a signal will sound for one (1) second on and

one (1) second off for 10 seconds if Signal for Start is

enabled.

After pressing the START keypad, the door will lock

and the cycle will begin.

Door Locking Mode

The control enters this mode after the START (enter)

keypad is pressed in Start Mode. The control stays in

Door Locking Mode until it confirms the door is

closed and locked.

Run Mode

The control enters this mode when a cycle is running.

The time remaining appears in the display, the status

LED’s are lit and the loading door is locked.

End of Cycle Mode

When a cycle is complete, the control will display “00”

until the washer door is opened, a key is pressed, or a

coin/card is entered. The display will revert back to Ready

Mode if door is opened or keypad is pressed. If vend is

entered, the control will change to Partial Vend Mode or

Start Mode.

Cycle Sequence

Upon the start of a cycle, the control will display the

total cycle time. The appropriate LEDs will light while

the machine passes through different cycle steps. Any

coin entered after the cycle has been started will be

ignored, but added to the total coin counter.

Door Unlocking Mode

The control enters this mode after cycle has ended. The

control waits for confirmation that door is unlocked.

Once confirmation is received that door is unlocked,

control will enter End of Cycle Mode.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 69 70

Comments to this Manuals

No comments

Alliance Laundry Systems HCN020HCF Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Washing machines Alliance Laundry Systems HCN020HCF