Alliance Laundry Systems HCN020HCF Instruction Manual download pdf (Page 25)

Programming Control

F8237701

3. Coin #2 Value “dEn2”

This option allows the owner to set a specific

numerical value for a coin entered when using the dual

coin drop. For example, the coin value for a dollar

coin would be measured in cents (100). Therefore, the

coin value entered for one dollar coin would be 00100.

If the Cycle Vend Price (option 1) is set for “2.00”,

and the Coin Value is set for “00100”, the vend price

displayed will decrease by 1.00 for each dollar coin

entered.

How to Program Coin #2 Value

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the Cold ( ) or the Delicate Cold ( )

keypad until “Prog” appears in the display. Press

the START (enter) keypad and “AtS” will appear

in the display.

3. Press the Cold ( ) or the Delicate Cold ( )

keypad to scroll through the programmable

options until “dEn2” appears in the display.

4. When “dEn2” appears in the display, press the

START (enter) keypad. There are five digits in

the Coin #2 Value. The fifth digit will appear in

the display and will flash one (1) second on and

one (1) second off. Refer to Figure 10.

NOTE: If the coin value is $100.00 or more, the

fifth digit is “1-6”. If the coin value is $99.99 or less,

the fifth digit is “0”.

Figure 10

5. Press the Cold ( ) or the Delicate Cold ( )

keypad to increase or decrease the value of the

fifth digit.

NOTE: The coin value can be set from 1 to 65,535.

The default coin value is 100.

6. Press the START (enter) keypad to enter the fifth

digit and display remaining four digits. The

active digit will flash one (1) second on and one

(1) second off.

NOTE: To go back to the current programmable

option without changing the value of the active

digit, press the Delicate Warm (<) keypad.

7. Press the Cold ( ) or the Delicate Cold ( )

keypad to increase or decrease the value of the

active digit and the START (enter) keypad to

enter the value of the digit and advance to the

next digit.

8. Press the START (enter) keypad with the last

active digit. The next option, “PLSE”, will

appear in the display.

NOTE: To program “PLSE” (Start Pulse Value),

refer to option 4. To program other options, refer to

the appropriate section.

How to Exit Programming Feature

Press the Delicate Warm (<) keypad until the control

returns to Ready Mode.

CHM507R

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 69 70

Comments to this Manuals

No comments

Alliance Laundry Systems HCN020HCF Instruction Manual Page 25

Comments to this Manuals

Related products and manuals for Washing machines Alliance Laundry Systems HCN020HCF