Alliance Laundry Systems BU170S Service Manual download pdf (Page 100)

70422201R1

LED OPL and UniLinc Troubleshooting

3. Connect one ohm meter probe to the connector in the basket shaft (Refer to Figure 13).

4. Connect the other ohm meter probe to one of the gray wire harness terminals on the back end of the machine

basket. If the metered value is less than 1 ohm, proceed to Step 5. If 1 ohm or greater, replace harness and

return to Paragraph 52.

5. Connect one ohm meter probe to the connector in the basket shaft.

6. Connect the other ohm meter probe to the other gray wire harness terminal on the back end of the machine

basket. If the metered value is less than 1 ohm, proceed to Step 7. If 1 ohm or greater, replace harness and

return to Paragraph 52.

7. Connect one ohm meter probe to the connector in the basket shaft.

8. Connect the other ohm meter probe to one of the moisture sensing baffles (refer to Figure 10). If the metered

value is less than 1 ohm, proceed to Step 9. If 1 ohm or greater, proceed to Paragraph 57.

9. Connect one ohm meter probe to the connector in the basket shaft.

10. Connect the other ohm meter probe to the other moisture sensing baffle. If the metered value is less than 1

ohm, circuit is functioning properly; double-check machine configuration and cycle programming. If 1 ohm

or greater, proceed to Paragraph 57.

57.Troubleshooting at the Moisture Sensing Baffles with Machine Basket

Removed

1. Disassemble moisture sensing baffle and inspect for lint buildup and foreign objects. Verify wire harness

connections.

2. Disassemble other moisture sensing baffle and inspect for lint buildup and foreign objects. Verify wire

harness connections.

3. Double-check machine configuration and cycle programming.

TMB2400S

1 Connector

2 Gray Wire Harness Terminal

Figure 13

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 119 120

No comments

Alliance Laundry Systems BU170S Service Manual Page 100