Alliance Laundry Systems SCU020JLF Instruction Manual download pdf (Page 9)

F8238301

Display Identification

Light Emitting Diodes (LEDs)

Refer to Figure 1.

Light Emitting Diodes (LEDs) are used to indicate the

chosen cycle, cycle status, if vend is needed, when the

bleach compartment is dispensing, and door lock

information. See below for information on each LED.

Cycle LED (NORMAL/90C, NORMAL/60C,

NORMAL/40C, PERM PRESS/90C, PERM

PRESS/60C, PERM PRESS/40C, PERM

PRESS/70C, PERM PRESS/50C and

DELICATE/30C)

Cycle LED will remain lit the entire cycle.

Wash LED

Wash LED is lit at the beginning of a wash portion of

the cycle and will remain lit until the wash is

complete.

Rinse LED

Rinse LED is lit at the beginning of a rinse portion of

the cycle and will remain lit until the rinse is complete.

Spin LED

Spin LED is lit during the Final Spin portion of the

cycle.

Door LED

Door LED is lit whenever the door is locked. The door

can’t be opened when this LED is lit.

Bleach LED

Bleach LED is lit when bleach compartment is

dispensing for the first time in the cycle.

Four 7-Segment Digits

The 7-Segment Digits are used to display the time

remaining in a cycle, vend price, error messages and

descriptive codes. During diagnostic testing or manual

programming of the control, these digits will display

descriptive codes and values (as described in Entering

the Manual Mode).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 108 109

No comments

Alliance Laundry Systems SCU020JLF Instruction Manual Page 9