© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
F8238301
14
Programming Control
What Can Be Programmed?
This feature allows the owner to program cycle
information, standard vend pricing, special vends and
other features by using the keypads. The control must
have the Manual Programming Mode enabled, which
is the factory default. This mode can only be turned
“OFF” and “ON” by using an external device. Refer to
this section when programming the control.
This section offers a detailed description of all available
programmable options.
Each description includes instructions on when and
why the option might be used and, more importantly,
how to program the option.
For more advanced users, a quick reference list of the
options available through the programming mode and
programming flowcharts are located on the following
pages.
NOTE: The letters and numbers in the Option
Display column of the Programmable Options
Available list are what will be shown in the display
when that option is selected.
Programmable Options Available
Option
Number
Option
Display
Description Default Value Value Range
1“AtS1” Normal/90C Vend Price 200 0 - 65535
2“dEn1” Coin #1 Value 25 1 - 65535
3“dEn2” Coin #2 Value 100 1 - 65535
4“PLSE” Start Pulse Value 25 1 - 65535
5“PLSn” Start Pulse Mode 128 oFF/128/192
6“AtyP” Available Type 00 - 3
7“dCYC” Default Cycle 5* 1-9*
8“oPL” OPL Mode Enable/Disable oFF on/oFF
9“AUd”Audio Signal 29* 0-31*
10 “CArd” Card Reader Display Control oFF on/oFF
11 “Err-” Errors --
a. “CEr-” Coin Error Parameters --
1. “CEr1” Coin Error on on/oFF
2. “CEr2” Coin Error Penalty oFF on/oFF
3. “CEr3” Coin Drops Header Present Error on on/oFF
b. “EFL” Fill Errors on on/oFF
c. “Edr”Drain Error on on/oFF
d. “EUb” Unbalance Error Display on on/oFF
e. “EoP” Open Thermister Error Display on on/oFF
f. “ESH” Shorted Thermistor Error Display on on/oFF
g. “EHt” Heat Error Display (Heater only) on on/oFF
*Refer to programming section for value definition.
**Refer to the Cycle Chart for default cycle setting information.
Table 1 (continued)
Comments to this Manuals