Alliance Laundry Systems SCU020JLF Instruction Manual download pdf (Page 11)

Machine Operation

F8238301

Signals

There are five options when a signal can be used during

the machine operation. These five options are listed

below:

1. End of Cycle Signal

By default, this signal is turned off. If turned on, the

signal sounds for three (3) seconds at the end of a

cycle.

2. Signal On Keypad Depression

By default, this signal is turned on and sounds for

a quarter of a second each time a keypad is pressed.

3. Signal On Coin Input/Card Insertion

By default, this signal is turned on and will sound

for a quarter of a second each time a coin or card

is entered.

4. Signal for Card Removal (Card Models Only)

By default, this signal is turned on and will sound

one (1) second on and one (1) second off when

the control is prompting for card removal.

5. Signal for Start

By default, this signal is turned on and will sound

one (1) second on and one (1) second off for 10

seconds after vend price has been satisfied.

NOTE: Refer to Programming Control to program

signal options.

Changing Cycles

Cycles can be changed anytime during the first Fill

step. After the first Fill step, all key presses are

ignored.

Selecting a higher priced cycle will pause the first Fill

step, and the Vend Price will flash one (1) second on and

one (1) second off until the vend price has been satisfied.

After the vend price has been satisfied, the cycle will

continue with the new selections. If the vend price is not

satisfied within one minute, the machine control will go

back to the previously set cycle.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 108 109

No comments

Alliance Laundry Systems SCU020JLF Instruction Manual Page 11