Alliance Laundry Systems STED17*H Instruction Manual download pdf (Page 60)

501506

Section IX

Collecting Audit Information

This feature allows the owner to retrieve audit

information by pressing a sequence of SELECT

CYCLE pads. For an explanation of the audit options

available, see the Audit Options List on this page.

How to Enter Audit Feature

1. Be sure the dryer is in the “Ready” mode

before continuing to step 2. See

Figure 3

. If the

dryer is in an active cycle, rapid advance

through the cycle (see the Rapid Advance

feature, Section XII ). If coins have been

entered, see the Clear Vend feature, (Section

XIII ).

2. Open and close the service door (see Section

VI).

3. While pressing and holding the HIGH TEMP

pad with one hand, press the MED TEMP pad

with the other hand. The VFD will show “SPC.”

4. While pressing and holding the HIGH TEMP

pad with one hand, press the LOW TEMP pad

with the other hand. The VFD display will

show the first Audit Option “CyC,”

Figure 96

NOTE: If the procedure did not work, the control

will return to “Ready” mode. See

Figure 3

DRYING

DOOR OPEN

COOL DOWN

PRICE

TIME REMAINING

INSERT COINS

PUSH START

C176IE1A

Figure 96

5. Go to

“How to Read Audit Data.”

How to Read Audit Data

1. Press the LOW TEMP (+), or NO HEAT(–) pad

to scroll through the audit options until the

desired option is displayed in the VFD. (Refer

to the Audit Options List below.)

Audit Options List

Audit

Option

Description

Total Audit

Range

"CyC"

Total number of

machine cycles

0 - 65,535

"CnS"

Total number of

coins

0 -

16,000,000

3 "nCy" Total number of

NO HEAT cycles

0 - 65,535

4 "ACy’ Total number of

Vend A cycles

0 - 65,535

5 "AnC" Total number of

Special Vend A

NO HEAT cycles

0 - 65,535

6 "COP" Total number of

coin vault

openings

0 - 65,535

7 "dOP" Total number of

service openings

0 - 65,535

8 "PFL" Total number of

power failures

0 - 255

9 "dnL" Total number of

downloads

0 - 255

2. Press the START (enter) pad once to start the

audit count. The first three-digit segment of

the count will appear in the VFD. Press the

START pad as required to scroll to the desired

three-digit audit count segment. See NOTE

below.

NOTE: Because the VFD can display up to three

digits at one time, audit counts higher than 999,

(i.e. 10,009), must be separated on individual

three-number segments. Each time the START

pad is pressed in step 2, the VFD will show the

next three-digit segment. Refer to

Chart 10

for the

range of each audit count.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 72 73

Comments to this Manuals

No comments

Alliance Laundry Systems STED17*H Instruction Manual Page 60

Comments to this Manuals

Related products and manuals for Washer dryers Alliance Laundry Systems STED17*H