17
501506
Stacked Washer and Dryer
Section VI
Opening the Service Door
Overview
Manually programming the Electronic Control
often
requires the operator to open and close the service
door. Opening and closing the service door trips a
switch allowing access to various programmable
options, diagnostics, and audit capabilities.
On stacked dryers and stacked washers and dryers,
the service door is located between the coin drops in
the control panel. See
Figure 7
.
On stand-alone dryers, the service door is located on
the top of the meter case, and on the front control
dryer, the service door is located in the control panel.
See
Figure 8
.
After opening and closing the service door, the
programmer has 4.25 minutes to begin programming.
If a SELECT CYCLE pad has not been pressed in that
time, the control will revert back to the “Ready” mode.
See
Figure 3
.
Figure 8
Figure 7
Stand-Alone Dryer
Stacked Dryer
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH TO START
NORMAL
HIGH
TEMP
PERM
PRESS
MID TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
UPPER
NORMAL
HIGH
TEMP
PERM
PRESS
MID TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
FABRICS AND TEMPERATURES
FABRICS AND TEMPERATURES
LOWER
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH TO START
C144IE3A
SERVICE
DOOR
C103IE3A
SERVICE
DOOR
Front Control Dryer
D449IE1B
OPERATING INSTRUCTIONS
CLEAN LINT FILTER AFTER EACH LOAD
1.
2.
3.
4.
5.
6.
Select Fabric Type (heat setting)
NORMAL, PERM PRESS,
DELICATE, FLUFF (no heat)
Load Clothes.
Insert Coin(s)/Card.
To Start Dryer - Close Door and Push Start.
To Stop Dryer During Cycle - Open Door.
To Restart Dryer - Close Door and Push Start.
Drying Cycle is Complete When
Panel Light Goes Off.
505605
START
HIGH
TEMP
MED
TEMP
LOW
TEMP
NO
HEAT
SERVICE
DOOR
NORMAL
HOT
PERM
PRESS
WARM
DELICATES
COLD
TO START
PUSH CYCLE PAD
BY FLASHING LIGHT
WASHER
DOOR
LOCKED
START
NORMAL
PERM
PRESS
HIGH TEMP
MED TEMP
DELICATES
LOW TEMP
TUMBLE
NO HEAT
505617
SERVICE
DOOR
D720IE1A
Comments to this Manuals