Alliance Laundry Systems STED17*H Instruction Manual download pdf (Page 13)

501506

When a cycle is complete, a signal will sound for three

seconds at one of three programmable volumes (if

selected). Dryers shipped from the factory have the

signal turned off. The signal (if selected) will sound at

the end of each cycle, when SELECT CYCLE pads

are pushed, or when coins are entered. Each of these

signals can be turned on or off separately (refer to

Section VIII, option 1, to program signal options).

When a cycle is complete, the VFD will display the

status word TIME REMAINING and “00” until the

door is opened. See

Figure 5

. When the door is

opened, the VFD display will revert back to the

“Ready” mode. See

Figure 3

Entering Coins

Coins are entered to satisfy the programmed vend

price for a selected cycle. Coins may be entered

before selecting a cycle or during an active cycle.

When coins are entered during an active cycle, the

time remaining is increased by the amount

programmed by the owner (refer to Section VIII,

option 17, when programming additional time-per-coin

options).

The owner may choose to add additional time for

each coin entered or may require an additional full

vend price to add time once a cycle has begun. If

coins are entered to an active heated cycle currently

in the COOL DOWN mode, more than one coin may

be required to push the cycle back into the DRYING

mode. The maximum time for any cycle is 99

minutes.

Changing Active Cycles

An active cycle may be changed at any time during

dryer operation. However, changing from one cycle to

another may require additional coins. If a newly

selected cycle requires additional coins, the additional

coins must be entered within 60 seconds.

If, for example, two additional coins are required to

fulfill the vend price for a new cycle, the dryer will

allow sixty seconds between coins entered. If the

vend price is not satisfied within that time, the dryer

will go back to the original cycle and the time

remaining is increased by the amount of coins

entered, depending on the additional time-per-coin

parameter.

Changing between heated cycles is allowed at any

time during the active DRYING portion of a heated

cycle. However, if the vend price is greater for a

heated cycle than a NO HEAT cycle, changing to a

heated cycle from a NO HEAT cycle is only allowed

during the first 3 and the final 5 minutes of the cycle.

In this case, the cycle will require additional coins.

Opening the Dryer Door

Opening the dryer door in a running cycle will

automatically stop the cycle. When the dryer door is

opened, the status word DRYING is turned off, and

the status words DOOR OPEN will flash at one-

second intervals,

Figure 6

NOTE: When the door is opened during an active

cycle, the time will continue to count down.

Once the dryer door is closed, the status words

DOOR OPEN goes off and the status word PUSH

START flashes at one-second intervals until the

START pad is pushed. Pressing the start pad will

start or resume the active cycle.

NORMAL

HIGH

TEMP

PERM

PRESS

MED TEMP

DELICATES

LOW

TEMP

TUMBLE

HEAT

START

FABRICS AND TEMPERATURES

DRYING

DOOR OPEN

COOL DOWN

PRICE

TIME REMAINING

INSERT COINS

PUSH START

C143IE1A

Figure 6

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 72 73

Comments to this Manuals

No comments

Alliance Laundry Systems STED17*H Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Washer dryers Alliance Laundry Systems STED17*H