Alliance Laundry Systems LTS99A*N1180 Service Manual Page 83

  • Download
  • Add to my manuals
  • Print
  • Page
    / 126
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 82
801803 81
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect all electric power to the machine and accessories before servicing.
Close gas shut-off valve to gas dryer before servicing.
Never start machine with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
59. DRYER DOOR SEAL
a. Remove inner door panel from outer door
panel. Refer to Paragraph 57.
b. Grasp either end of door seal at bottom of door
and remove seal from tabs on inner door panel
by gently pulling on the seal. Refer to
Figure 33.
NOTE: When replacing seal, be sure seal is not
stretched or distorted. The tab in the seal should be
installed in each slot of the inner door panel, shown
in Figure 33. The split in the seal must be at the
bottom of the door. Make sure that each tab of the
seal is fully engaged into the slot.
Figure 33
H182SE3A
Door Seal
Tab
Inner Door
Panel
Door Seal
Inner Door
Panel Slot
Bottom Of Door
Page view 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 125 126

Comments to this Manuals

No comments