Alliance Laundry Systems LTS99A*N1180 Service Manual Page 82

  • Download
  • Add to my manuals
  • Print
  • Page
    / 126
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 81
80 801803
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect all electric power to the machine and accessories before servicing.
Close gas shut-off valve to gas dryer before servicing.
Never start machine with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
57. DRYER INNER AND OUTER DOOR
PANELS AND DOOR PULL
a. Remove four screws holding door assembly to
hinges. Refer to Figure 31.
b. Remove remaining screws around the door
assembly and separate panels. Refer to
Figure 32.
c. Remove wedge (located behind door pull) by
carefully prying up on center of wedge. Refer to
Figure 32.
d. Remove door pull. Refer to Figure 32.
58. DRYER DOOR STRIKE
a. Open loading door.
b. Remove screw holding door strike and bracket
to loading door and remove strike and bracket.
Refer to Figure 32.
NOTE: You may have to loosen the two screws on
end of door to allow for strike and bracket removal.
Figure 32
D387PE3A
Door Seal
Door
Strike
Door Hinge
Door Strike
Bracket
Screws
Inner Door Panel
and Seal Assembly
Screw
Door
Pull
Wedge
Screw
Front
Panel
Outer Door
Panel
Page view 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 125 126

Comments to this Manuals

No comments