Alliance Laundry Systems CHM166C Installation Manual download pdf (Page 9)

F232133

Programming

The wash cycle program in machines equipped with a

mechanical timer can be modified to a limited extent.

The following changes can be made:

● The prewash time may be set to 2 minutes,

4 minutes, or omitted altogether.

● The wash time may be set to either 4 minutes or

8 minutes. The water level for the wash step may

be set to either low or high.

● The water temperature for the rinses may be set

to either cold or warm.

● The final spin time may be set to either 2 minutes

or 4 minutes.

Setting the Jumpers With Circuit

Board

NOTE: The odd-numbered side of the timer is used

to change the duration of individual cycle steps.

The even-numbered side of the timer is used to

adjust the rinse temperature or to change the water

level for the wash step.

1. Disconnect the power to the machine.

2. Unlock and raise top cover.

3. Remove control module cover.

4. Locate the mechanical timer in the middle of the

control module.

5. Install or remove jumpers on the odd side to set

desired cycle time. Refer to Figure 1 and Table 1

for jumper configurations for odd-side options.

Figure 1

Hazardous Voltage. Can cause shock,

burn or cause death. Turn off power

before removing control box cover and

before attempting any service

procedures.

W356

WARNING

B165R

JP1

JUMPER INSTALLED

JUMPER REMOVED

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Alliance Laundry Systems CHM166C Installation Manual Page 9