Alliance Laundry Systems 1336 Service Manual download pdf (Page 59)

58 F238006

Section 4 Troubleshooting

13. AUTOMATIC SUPPLY DISPENSER ANALYSIS

Program and run the following steps into any available cycle to test the system.

NOTE: Pre-programmed cycle 39 already has a portion of this cycle pre-programmed into it.

Run the cycle and, with the respective supply on the main display, refer to the following chart for the function

that should be occurring:

During each step, test for voltage (220 Volts) between each respective supply terminal and the common

terminal on the XT3 terminal strip.

NOTE: The XT3 terminal strip is located toward the back of the control module, next to the power input

block.

Step Description Program Min:sec

1 Warm Fill to Low Level Warm Fill 5:00

2 Supply 1 Supply 1 2:00

3 Supply 2 Supply 2 2:00

4 Supply 3 Supply 3 2:00

5 Supply 4 Supply 4 2:00

6 Supply 6 Supply 5 and 1 2:00

7 Supply 7 Supply 5 and 2 2:00

8 Supply 8 Supply 5 and 3 2:00

9 Supply 9 Supply 5 and 4 2:00

10 Wash 1 Wash :30

11 Drain 1 Drain 1:00

Supply Function

1 Flushes Compartment 1

2 Flushes Compartment 2

3 Flushes Compartment 3

4 Flushes Compartments 4 and 5

6 Flushes Compartment 1

7 Flushes Compartment 2

8 Flushes Compartment 3

9 Flushes Compartments 4 and 5

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 94 95

No comments

Alliance Laundry Systems 1336 Service Manual Page 59