Alliance Laundry Systems 30 Pound Capacity Operations Instructions download pdf (Page 28)

Maintenance

70380401 (EN)

Monthly

1. Remove lint and debris from inside exhaust duct

to maintain proper airflow and avoid

overheating.

a. Remove external duct and duct access covers,

if present.

b. Clean inside of duct with a vacuum.

c. Clean dampers and make sure they operate

freely.

d. Replace duct and all access covers before

returning tumble dryer to operation.

2. Ensure even lint distribution over lint screen,

replace if distribution of lint is uneven to

maintain proper airflow and avoid overheating.

3. Carefully wipe any accumulated lint off the

cabinet high limit thermostat and thermistor,

including perforated cover. Lint buildup will act

as an insulator, causing machine to overheat.

4. Clean lint and debris buildup from blower to

maintain proper airflow, to avoid overheating and

prevent possible vibration.

Quarterly

1. Use a vacuum to clean air vents on drive motors.

2. Use a vacuum to clean lint from rear limit

thermostat cover.

3. Check and clean steam coils, if applicable.

4. Check flow of combustion and ventilation air.

5. Check belt tension and condition. Replace worn

or cracked belts.

Bi-Annually

1. Check mounting hardware for any loose nuts,

bolts or screws.

2. Check gas connections for leakage.

3. Check for loose electrical connections.

4. Check steam connections for looseness and

leakage.

5. Remove all front panels and vacuum, including

coin drop mechanisms.

6. Check cylinder and front panel seals.

7. Inspect cabinet and inner panels for any damage,

replace or repair as needed.

8. Clean burner tubes and orifice area of any lint

buildup.

Annually

1. Remove cylinder. Use a vacuum to clean lint

from area around rear seal and idler assembly.

Check seal and idler assembly for wear.

2. Remove burner tubes and clean using water and a

brush.

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the tumble dryer before servicing.

• Close gas shut-off valve to gas tumble dryer before servicing.

• Close steam valve to steam tumble dryer before servicing.

• Never start the tumble dryer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the tumble dryer is properly grounded.

W002R1

WARNING

1 2 ... 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Alliance Laundry Systems 30 Pound Capacity Operations Instructions Page 28

Comments to this Manuals

Related products and manuals for Electric laundry dryers Alliance Laundry Systems 30 Pound Capacity