36528
5
Section 1
Electronic Control Error Code Listing
Listed below are some of the error codes that may appear on the Electronic Control.
NOTE: Disconnecting power to the unit may clear the error display.
“E:00” General Error
“E:01” Proximity Error Micro-wand IIIe is improperly aimed at Infrared communicator (angle or
distance): Reaim Micro-wand IIIe.
“E:02” IR Communication
Disconnection
Micro-wand IIIe prematurely pulled away from Electronic Control during
infrared communication: Maintain infrared connection between Micro-wand
IIIe and Electronic Control during communication.
“E:05” Invalid Value
Communication
Invalid code downloaded from Micro-wand IIIe to Electronic Control:
“E:07” Inoperative Control Replace Electronic Control.
“E:08” Inoperative Control Replace Electronic Control.
“E:09” Proximity Error Micro-wand IIIe is improperly aimed at Infrared communicator (angle or
distance): Reaim Micro-wand IIIe.
“E:0A” Proximity Error Micro-wand IIIe is improperly aimed at Infrared communicator (angle or
distance): Reaim Micro-wand IIIe.
“E:0B” IR Communication
Disconnection
Micro-wand IIIe prematurely pulled away from Electronic Control during
infrared communication: Maintain infrared connection between Micro-wand
IIIe and Electronic Control during communication.
“E:0C” IR Communication
Disconnection
Micro-wand IIIe prematurely pulled away from Electronic Control during
infrared communication: Maintain infrared connection between Micro-wand
IIIe and Electronic Control during communication.
“E:0d” Pressure Switch Error 1. Check fill and drain hoses for improper installation and kinks.
2. Check fill electrical circuit: Replace inoperative switches or wires.
“E:0F” IR Communicator
Programmed Off
Reprogram infrared communicator on.
“Err” Coin Error 1. Inoperative coin sensor: Run the Coin Drop Diagnostic test.
2. Coin drop obstruction: Check coin drop area and remove any obstructions.
3. Customer tampering: Evaluate security procedures.
“OP” Open Thermistor Physical opening in the thermistor circuit: Change thermistor.
“SH” Shorted Thermistor Dead short in the thermistor circuit: Change thermistor.
(78 pages)
(31 pages)
(104 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals