Alliance Laundry Systems SWD439C Specifications download pdf (Page 31)

Installation

801546

Exhaust System Maintenance

The dryer interior and the complete exhaust system

should be inspected after one year of use and cleaned

if necessary. Inspect and clean exhaust duct every one

to two years as required thereafter. The weather hood

should be checked frequently to make sure the

dampers move freely, dampers are not pushed in and

that nothing has been set against them. This

maintenance work should be done by a qualified

service person.

Exhausting the dryer in hard-to-reach locations can be

accomplished by installing the 521P3 Flexible Metal

Vent Kit, available as optional equipment at extra cost.

The kit comes in two halves that can be separately

attached to the dryer and wall outlet. Once attached,

the unit can be slid back into position.

Figure 29

Dryer Airflow

Efficient dryer operation requires proper dryer airflow.

Proper dryer airflow can be evaluated by measuring

the static pressure.

Static pressure in the dryer’s exhaust duct should be no

greater than that shown in Figure 30. (Check with

dryer running and no load.)

NOTE: This can be measured with a manometer

placed on the exhaust duct approximately 61 cm

(2 feet) from the dryer. Refer to Figure 30.

Figure 30

SWD647N

To reduce the risk of electric shock,

disconnect the electrical service to the dryer

before cleaning.

W043

WARNING

521P3 FLEXIBLE METAL VENT KIT

D012I

1 Manometer

2 Exhaust Duct

DR012A-IN

MAXIMUM STATIC

PRESSURE IN

WATER COLUMN

1.5 cm (0.6 in.)

MEASURING STATIC PRESSURE

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 69 70

Comments to this Manuals

No comments

Alliance Laundry Systems SWD439C Specifications Page 31

Comments to this Manuals

Related products and manuals for Electric laundry dryers Alliance Laundry Systems SWD439C